Posts Tagged

lowering

1964 Chevy Truck inner fender
BlogTechnically Speaking

After the completion of the Z-ing of the chassis, it was time to start modifying the stock inner fenders. Not wanting to eliminate them completely or going with an aftermarket inner fender, Alex took up the challenge to rework the stock units to make them look factory. At the same time, the firewall was repaired, reworked and painted as well.

Read More
1964 Chevy truck front boxing plate
Technically Speaking

Project White Trash finally got put back on it’s wheels after getting the rear axle narrowed, but the excitement wears off quickly. A quick glance at the lower control arms reveals that they are so low to the ground that they’ll hit on every crown in the road. After researching a lot of suspension options and coming to the conclusion that they are not in the budget, Alex recalls a decades-old conversation with a friend about an extremely cost-effective option. Little did he know that the wheels were already in motion, and the decision to do this mod was already made.

Read More
1964 Chevy C10 front 3/4 shot
Technically Speaking

Project White Trash gets its rear axle narrowed to fit the ET Super wheels that were restored in the previous episode. Alex also bends up new rear brake lines and decides on the ride height. Once that gets determined, the truck finally comes off of the jack stands and gets back on it’s wheels for the first time in a long while.

Read More